Product has been sourced and tested on our own upgraded Anet A8 3D printers to ensure compatibility and stability. Please note it is intended only for use on those printers which have already been upgraded to use a cartridge style heat block. It will not fit the standard Anet block
- NTC Thermistor 100k Ohm 3950K
- 3mm diameter x 15mm Brass Cartridge
- Compatible with latest e3d V6 & Lite6 Hot Ends and others using a 3mm cartridge thermistor.
- Crimped cartridge & fibre glass sleeved for improved strain relief and heat protection
- Unlike other cartridge thermistors, this has a Beta value of 3950k which means there is no need to reprogram your standard firmware set up.
- 90cm Extension lead terminates in a 3 pin JST for direct connection to the Anet style control boards
Write a review and share your thoughts with other shoppers.