Replacement 24V All metal V5 J-head Hot End 0.4/1.75mm For Anycubic Chiron

This is a drop in replacement for the V5 J-Head Hotend on the Anycubic I3 Chriron 3D Printer.

Full assembled complete with Thermistor and 40W 24V Heater, suitable for 1.75mm Filament, only.

PLEASE NOTE -THIS VERSION HAS AN ALL METAL THREADED HEATBREAK

Not a smooth one as supplied by the OEM.

If in doubt please ask.

This is a low cost solution, that can give good prints, the all metal construction means that in theory higher temperature printing is possible, however the overall length of the heatbreak means that adequate cooling is critical otherwise blockages can easily occur, we would recommend the use of thermal compound when fitting the heatbreak and consideration should be given to increasing the cooling of the heatsink,